Are you using a cold-bending machine?

Cold-bending The characteristics of the equipment have been introduced in the front, so that we have some knowledge and understanding of the equipment, but for us, it is not enough to just understand these, but also need to know more. With regard to the common sense of cold-formed forming equipment, it is necessary to adjust the scope of this aspect and add our common sense.

Before starting work, check the machine's power supply, motor oil pump, pressure gauge, relief valve, electro-hydraulic valve, and jog switch. Is it normal? If there is any problem, if any, Process it to ensure that the machine can work smoothly. Jog the motor, mainly to check whether the direction of rotation is correct.

After the above contents are checked, there is no problem, then the motor is recommended, and then the hydraulic pressure is adjusted to 10 MPa, and then the test is run for about three minutes. Assuming there are no problems, then you can officially start your homework. Machines and equipment should be installed on a robust and robust basis and should be flat. Before applying, add oil and hydraulic oil, and then replace it regularly.

To properly use the machine, follow the rules and procedures, and follow the operating procedures and safe operating procedures. If there is no oil in the fuel tank, stop the recommended motor and avoid damage. The amount of oil in the fuel tank should be sufficient. If the oil quantity is lacking, it should be added in time. The lubrication of the equipment should be excellent, so check it often. Machines and equipment are assumed to be used for a long time, so rust prevention should be done beforehand to avoid rusting of the machine.

In the days when cold-forming equipment is used more and more, we must know clearly when the application of cold-bending equipment is different from the press. We know that these differences are applied later. There will be no problem with the time, let's talk about the difference.

The cold-bending machine requires a multi-system collaborative collaboration to be successfully completed. The door bracket of the auxiliary system places the profile steel between the automatic rollers, and the hydraulic system makes the hydraulic cylinder dovetail groove. Cold-formed steel with cold-formed rollers closes the hydraulic system when it reaches the arc required by the design. This is the start of the mechanical transmission system to push the profile steel forward.

Then continue the cold bend. This cold bending operation is much more energy efficient than the traditional press method. It has low noise, no pollution, high operating efficiency and long service life, so the application range of the cold bending machine is very wide.